You cannot select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.

2.7 KiB

Raw Blame History

Using Ubuntu Server as a Client with WireGuard

Install WireGuard

To connect to your AlgoVPN using WireGuard from Ubuntu Server, first install WireGuard:

# Add the WireGuard repository:
sudo add-apt-repository ppa:wireguard/wireguard

# Update the list of available packages (not necessary on Bionic or later):
sudo apt update 

# Install the tools and kernel module:
sudo apt install wireguard

For installation on other Linux distributions, see the Installation page on the WireGuard site.

Locate the Config File

The Algo-generated config files for WireGuard are named configs/<ip_address>/wireguard/<username>.conf on the system where you ran ./algo. One file was generated for each of the users you added to config.cfg. Each WireGuard client you connect to your AlgoVPN must use a different config file. Choose one of these files and copy it to your Linux client.

Configure DNS

Ubuntu 18.04 (Bionic)

If your client is running Bionic (or another Linux that uses systemd-resolved for DNS but does not have resolvectl or resolvconf installed) you should first edit the config file. Comment out the line that begins with DNS = and replace it with:

PostUp = systemd-resolve -i %i --set-dns=172.16.0.1 --set-domain=~.

Use the IP address shown on the DNS = line (for most, this will be 172.16.0.1). If the DNS = line contains multiple IP addresses, use multiple --set-dns= options.

Ubuntu 18.10 (Cosmic) or 19.04 (Disco)

If your client is running Cosmic or Disco (or another Linux that uses systemd-resolved for DNS and has resolvectl but not resolvconf installed) you can either edit the config file as shown above for Bionic or run the following command once:

sudo ln -s /usr/bin/resolvectl /usr/bin/resolvconf

Other Linux Distributions

On other Linux distributions you might need to install the openresolv package.

Configure WireGuard

Finally, install the config file on your client as /etc/wireguard/wg0.conf and start WireGuard:

# Install the config file to the WireGuard configuration directory on your
# Linux client:
sudo install -o root -g root -m 600 <username>.conf /etc/wireguard/wg0.conf

# Start the WireGuard VPN:
sudo systemctl start wg-quick@wg0

# Check that it started properly:
sudo systemctl status wg-quick@wg0

# Verify the connection to the AlgoVPN:
sudo wg

# See that your client is using the IP address of your AlgoVPN:
curl ipv4.icanhazip.com

# Optionally configure the connection to come up at boot time:
sudo systemctl enable wg-quick@wg0

If your Linux distribution does not use systemd you can bring up WireGuard with sudo wg-quick up wg0.

2.7 KiB Raw Blame History