mirror of
https://github.com/timmbogner/Farm-Data-Relay-System
synced 2024-11-10 07:10:42 +00:00
45 lines
2.8 KiB
Markdown
45 lines
2.8 KiB
Markdown
# Gateway 2.000
|
|
The FDRS Gateway listens for packets over ESP-NOW, UART, LoRa, and/or MQTT, then retransmits the packets over these interfaces using rules defined in the "Actions" section of the configuration file.
|
|
|
|
## Actions
|
|
Actions define how the gateway reacts to a packet recieved via each data source. An action may be comprised of one or multiple commands separated by (and terminated with) semicolons.
|
|
|
|
## Options
|
|
### ```#define UNIT_MAC (0xNN)```
|
|
The UNIT_MAC is the ESP-NOW and LoRa address of the gateway. This is the address that nodes or other gateways will use to pass data to this device.
|
|
### ```#define DEBUG```
|
|
This definition enables debug messages to be sent over the serial port. If disabled, the USB serial port is still used to echo data being sent via the sendSerial() command.
|
|
### ```#define RXD2 (pin)``` and ```TXD2 (pin)```
|
|
These are the pins for inter-device serial communication. The single ESP8266 serial interface is not configurable, and thus these options only apply to ESP32 boards.
|
|
### ```#define USE_LORA```
|
|
Enables LoRa. Make sure that you set the LoRa module configuration parameters in the lines below.
|
|
|
|
BAND and SF (spreading factor) can also be configured in 'fdrs_globals.h' if enabled.
|
|
### ```#define USE_WIFI```
|
|
Enables WiFi. Used only on the MQTT gateway.
|
|
|
|
SSID, password, and MQTT credentials are also configurable in 'fdrs_globals.h'.
|
|
### #define USE_LED
|
|
This option initializes FastLED! I haven't developed this very much, perhaps you have ideas?
|
|
|
|
## Peers
|
|
### Routing
|
|
In addition to reacting to packets from general (unknown) ESP-NOW and LoRa devices, the gateway can also listen for traffic from a specific peer's device address (MAC) and react differently than it would to general traffic. This can be used to 'propel' packets upstream or downstream and allows the user to define different paths for data originating from either direction. The user can define up to two peer addresses each for the ESP-NOW and LoRa interfaces (ESPNOW1 & ESPNOW2 and LORA1 & LORA2).
|
|
### Buffers
|
|
Each peer also has a send buffer associated with it. Buffers are enabled by uncommenting their cooresponding DELAY macro (ex: ```#define LORAG_DELAY 1000```). When enabled, the gateway will automatically send the buffer contents at the interval specified. Buffers can hold a maximum of 256 DataReadings.
|
|
|
|
While ESP-NOW is quick enough to handle a lot of traffic in real-time, LoRa is much slower. For this reason, you must send LoRa data to a buffer and transmit it at standard intervals. Since buffers are mandatory, a LoRa repeater always needs to be configured using a LoRa peer.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|