Some network and application specific code does not belong in the protocol module and was moved.
Eventloop, recovery and the outside behaviour were moved to the respective application module because they are application specific.
The `swap_setup` was moved into the network module because upon change both sides will have to be changed and should thus stay close together.
- Swap-id is exchanged during execution setup. CLI (Bob) sends the swap-id to be used in his first message.
- Transfer poof and encryption signature messages include the swap-id so it can be properly associated with the correct swap.
- ASB: Encryption signatures are associated with swaps by swap-id, not peer-id.
- ASB: Transfer proofs are still associated to peer-ids (because they have to be sent to the respective peer), but the ASB can buffer multiple
- CLI: Incoming transfer proofs are checked for matching swap-id. If a transfer proof with a different swap-id than the current executing swap is received it will be ignored. We can change this to saving into the database.
Includes concurrent swap tests with the same Bob.
- One test that pauses and starts an additional swap after the transfer proof was received. Results in both swaps being redeemed after resuming the first swap.
- One test that pauses and starts an additional swap before the transfer proof is sent (just after BTC locked). Results in the second swap redeeming and the first swap being refunded (because the transfer proof on Bob's side is lost). Once we store transfer proofs that we receive during executing a different swap into the database both swaps should redeem.
Note that the monero harness was adapted to allow creating wallets with multiple outputs, which is needed for Alice.
The request-response behaviour that is used for sending the transfer
proof actually has a functionality for buffering a message if we
are currently not connected. However, the request-response behaviour
also emits a dial attempt and **drops** all buffered messages if this
dial attempt fails. For us, the dial attempt will very likely always
fail because Bob is very likely behind NAT and we have to wait for
him to reconnect to us.
To mitigate this, we build our own buffer within the EventLoop and
send transfer proofs as soon as we are connected again.
Resolves#348.
