2
0
mirror of https://github.com/opnsense/docs synced 2024-11-15 06:12:58 +00:00
opensense-docs/source/manual/how-tos/nut.rst

49 lines
1.8 KiB
ReStructuredText

==========================
NUT - Network UPS Tools
==========================
--------------------------
What is NUT
--------------------------
NUT is a tool that enables the use of a UPS device via either USB or Network communication. If enabled, the system will shutdown when the UPS emits a low battery warning.
--------------------------
Installation
--------------------------
NUT is available as a plugin in OPNSense via the plugin **os-nut**. You can install the plugin via **System > Firmware > Plugins > os-nut**.
--------------------------
How to Setup - Netclient
--------------------------
1. Navigate to the NUT services page and fill in the following values, then click apply:
==================== ============================================
Enable NUT Checked
Service Mode netclient
Name <choose a name>
Listen Address <interface ip on which the server lives>
==================== ============================================
2. Click on the arrow down next to **UPS Type** and choose **Netclient**.
.. image:: images/nut_netclient_dropdown.png
3. Fill in these values, then click apply:
==================== ============================================
Enable Checked
IP Address <ip of NUT Server>
Username <username, if applicable>
Password <password, if applicable>
==================== ============================================
4. Click on **Diagnostics** in the left menubar. If configured correctly this page will show, after waiting a few seconds, information about the UPS. Look for **device.mfr** and **device.model** to check if the correct UPS is detected.
.. image:: images/nut_diagnostics.png
--------------------------
References
--------------------------
- `Official website of NUT <https://networkupstools.org/>`__