:orphan: ============================ WireGuard Site-to-Site Setup ============================ .. Warning:: **IMPORTANT NOTE** : WireGuard Plugin is still in development, use at your own risk! ------------ Introduction ------------ WireGuard is a simple and fast modern VPN. It aims to be faster and simpler than IPSec. It intends to be considerably more performant than OpenVPN. Initially released for the Linux kernel, it is now cross-platform and widely deployable. It is currently under heavy development. --------------------- Step 1 - Installation --------------------- Since WireGuard Plugin is still in development you have to switch via **System->Firmware->Settings** the **Release Type** to **Development**. After this go to **System->Firmware->Plugins->** and search for **os-wireguard-devel**. Install the plugin as usual, refresh and page and the you'll find the client via **VPN->WireGuard**. ------------------------ Step 2 - Setup WireGuard ------------------------ The setup of a Site-2-Site VPN is very simple. Just go to tab **Server** and create a new instance. Give it a **Name** and set a desired **Listen Port**. If you have more than one server instance be aware that you can use the **Listen Port** only once. For **Tunnel Address** choose a new virtual network to run communication over it, just like with OpenVPN or GRE (e.g. 192.168.0.1/24). **Peers** can not be chosen yet since we have not created them yet. After hitting **Save changes** you can reopen the newly created instance, write down your new public key and give it to the other side. When this VPN is set up on OPNsense only do the same on the second machine and exchange the public keys. Now go to tab **Endpoints** and add the remote site, give it a **Name**, insert the **Public Key** and the **Tunnel Address** (e.g. 192.168.0.2/24). **Endpoint Address** is the public IP of the remote site and you can also set optionally the **Endpoint Port**, now hit **Save changes**. Go back to tab **Server**, open the instance and choose the newly created endpoint in **Peers**. Now we can **Enable** the VPN in tab **General** and go on with the setup. ----------------------- Step 3 - Setup Firewall ----------------------- On **Firewall->Rules** add a new rule on your WAN interface allowing the port you set in your instance (Protocol UDP). You also have a new interace **Wireguard** in rules, where you can set granular rules on connection inside your tunnel. Your tunnel is now up and running. ------------------------- Step 4 - Routing networks ------------------------- If you want to route your internal networks via this VPN just add the network in the **Tunnel Address** in **Endpoints** tab (e.g. 10.0.1.0/24). That's it!