After the FeePPM miner fee fix there has probably been a race condition
in this test. The test would expect only one of the two quotes to work,
as one had a marginally high miner fee. After the FeePPM fix that miner
fee was considered valid and we dispatched two swaps instead of one,
with the test setup examining the first one that reached the go channel.
Previously we would exclusively pass the autoloop boolean to multiple
functions while they had directly access to the manager's parameters.
With this commit we remove this explicit flag from the various function
interfaces and retrieve the value directly from the parameters.
Adds the easy autoloop function which executes a budget update and the
best easy-autoloop swap. The easy-autoloop function re-uses functions
used in the normal autoloop that relate to on-going swaps and traffic
summary.
This commit removes all code related to NP2WSH htlcs. These were
historically used when segwit adoption was very sporadic and are not
used anywhere anymore. Some historical swaps stored in the DB may be
listed with incorrect htlc adresses from here on.
This commit saves the RPC request used to construct the `Parameters` on
disk. Since it's a proto message, an easy way to read/write it is to
rely on the proto marshal/unmarshal methods. A side effect is that
migration also becomes easy as proto message have its own internal
mechanism to keep track of the compatibility.
This commit refactors the method `manager.SetParameters` to take a
`SetLiquidityParamsRequest`. As we'll see in the following commit, this
will enable us saving the params to disk more easily.
We already have a Label field in the embedded SwapContract
field for loop in swaps. This commit removes an erroneously
added Label field in LoopInContract which may be a cause of
ambiguity when referencing this field.
Add an implementation of our swap interface which can be used for
loop in, and fee estimation. For fee estimation, we always want to
calculate worst case loop in fees, so that autoloop never goes over
its budget. However, for loop in we can't estimate how much a
timeout would cost, because we must sweep the output (can't set
a limit like loop out), and fee estimation in a few hundred blocks
(when we'd sweep the timeout) is totally unreliable.
Instead, we use a high fee rate as our best-effort fee rate for
the future. We can also be confident that that loop in swaps will
succeed, since once the htlc is locked in, all that is required
is for the server to sweep.
In preparation of supporting multiple swap types, we move our swap
builder into a single place, so that we can check our `maySwap`
restriction per-swap (since we'll now have different checks for
different swap types.
To save ourselves from making multiple calls to the loop server for
the restrictions placed on each swap type, we still pass a single
set of restrictions in.
In preparation for adding loop in swaps, we relate liquidity rules
to a specific type of swap that we want to dispatch. This allows us
to use a single rule format for multiple swap types.
The current wording in this function is very specific to loop out.
In this commit, we refactor to use `target` and `reserve` rather
than inbound and outbound so that it can be used more generically.
To allow code with more up-to-date dependencies to import loop, we
bump our lndclient version. The minimum loop version remains 11.1
since we're not using any new apis.
This commit adds a peer listing function to our generic swap
interface, which we will use to set reasons for swaps that are
specified by peer pubkey rather than channel.
