Make sure we only send Suspend/Resume events when we *actually* suspend/resume. This is done via the Device `_beforeSuspend`/`_afterResume` methods, and those were called by the *input handlers*, not the PM logic; which means they would fire, while the PM logic could actually take a smarter decision and *not* do what the event just sent implied ;).
(i.e., sleep with a cover -> suspend + actual suspend, OK; but if you then resume with a button -> input assumes resume, but PM will actually suspend again!).
Existing design issue made more apparent by #9448 ;).
Also fixes/generalizes a few corner-cases related to screen_saver_lock handling (e.g., don't allow USBMS during a lock).
And deal with the fallout of the main change to the Kobo frontlight ramp behavior ;).
Much easier to deal with thanks to the cleanup work done in #10062 ;).
* `carrier` is set to 1 as soon as the device is *administratively* up (in practice, as soon as we run `ifconfig up`). This is perfectly fine for `isWifiOn`, but absolutely not for `isConnected`, because we are not, actually, connected to *anything*, no attempt at associating has even been made at that point. Besides being semantically wrong, in practice, this will horribly break the connectivity check, because it expects that `isConnected` means we can talk to at least the LAN.
* Delving into the Linux docs reveals that `operstate` looks like a better candidate, as it reflects *operational status*; for Wi-Fi, that means associated and successfully authenticated. That's... closer, but still not it, because we still don't have an IP, so we technically can't talk to anything other than the AP.
* So, I've brought out the big guns (`getifaddrs`), and replicated a bit of code that I already use in the USBNetwork hack on Kindle, to detect whether we actually have an IP assigned. (Other approaches, like `/proc/net/route`, may not be entirely fool-proof, and/or get complicated when IPv6 enters the fray (which it does, on Kobo, Mk. 8+ devices are IPv6-enabled)).
TL;DR: Bunch of C via ffi, and `isConnected` now returns true only when the device is operationally up *and* we have an IP assigned.
Pulls in https://github.com/koreader/koreader-base/pull/1579 & https://github.com/koreader/lj-wpaclient/pull/10
cervantes kindle kobo remarkable: use sysfs carrier file to determine connection state
cleanup hasWifiManager checks
gateway check: use ip if available
Fixes: #10087Closes: #10092
* Get rid of the `canToggleGSensor` Device cap, it's now mandatory for `hasGSensor` devices. (This means Kindles can now toggle the gyro, fix#9136).
* This also means that `Device:toggleGSensor` is now implemented by `Generic`.
* Update the Screen & Gyro rotation constants to be clearer (c.f., https://github.com/koreader/koreader-base/pull/1568) (/!\ This might conceivably break some `rotation_map` user-patches).
* Input: Move the platform-specific gyro handling to Device implementations, and let Input only handle a single, custom protocol (`EV_MSC:MSC_GYRO`).
* Input: Refine the `rotation_map` disable method implemented in 43b021d37c. Instead of directly poking at the internal field, use a new method, `disableRotationMap` (/!\ Again, this might break some `rotation_map` user-patches).
* Input: Minor tweaks to event adjust hooks to make them more modular, allowing the Kobo implementation to build and use a single composite hook. API compatibility maintained with wrappers.
Basically:
* Use `extend` for class definitions
* Use `new` for object instantiations
That includes some minor code cleanups along the way:
* Updated `Widget`'s docs to make the semantics clearer.
* Removed `should_restrict_JIT` (it's been dead code since https://github.com/koreader/android-luajit-launcher/pull/283)
* Minor refactoring of LuaSettings/LuaData/LuaDefaults/DocSettings to behave (mostly, they are instantiated via `open` instead of `new`) like everything else and handle inheritance properly (i.e., DocSettings is now a proper LuaSettings subclass).
* Default to `WidgetContainer` instead of `InputContainer` for stuff that doesn't actually setup key/gesture events.
* Ditto for explicit `*Listener` only classes, make sure they're based on `EventListener` instead of something uselessly fancier.
* Unless absolutely necessary, do not store references in class objects, ever; only values. Instead, always store references in instances, to avoid both sneaky inheritance issues, and sneaky GC pinning of stale references.
* ReaderUI: Fix one such issue with its `active_widgets` array, with critical implications, as it essentially pinned *all* of ReaderUI's modules, including their reference to the `Document` instance (i.e., that was a big-ass leak).
* Terminal: Make sure the shell is killed on plugin teardown.
* InputText: Fix Home/End/Del physical keys to behave sensibly.
* InputContainer/WidgetContainer: If necessary, compute self.dimen at paintTo time (previously, only InputContainers did, which might have had something to do with random widgets unconcerned about input using it as a baseclass instead of WidgetContainer...).
* OverlapGroup: Compute self.dimen at *init* time, because for some reason it needs to do that, but do it directly in OverlapGroup instead of going through a weird WidgetContainer method that it was the sole user of.
* ReaderCropping: Under no circumstances should a Document instance member (here, self.bbox) risk being `nil`ed!
* Kobo: Minor code cleanups.
* UIManager: Support more specialized update modes for corner-cases:
* A2, which we'll use for the VirtualKeyboards keys (they'd... inadvertently switched to UI with the highlight refactor).
* NO_MERGE variants of ui & partial (for sunxi). Use `[ui]` in ReaderHighlight's popup, because of a Sage kernel bug that could otherwise make it translucent, sometimes completely so (*sigh*).
* UIManager: Assorted code cleanups & simplifications.
* Logger & dbg: Unify logging style, and code cleanups.
* SDL: Unbreak suspend/resume outside of the emulator (fix#9567).
* NetworkMgr: Cache the network status, and allow it to be queried. (Used by AutoSuspend to avoid repeatedly poking the system when computing the standby schedule delay).
* OneTimeMigration: Don't forget about `NETWORK_PROXY` & `STARDICT_DATA_DIR` when migrating `defaults.persistent.lua` (fix#9573)
* WakeupMgr: Workaround an apparent limitation of the RTC found on i.MX5 Kobo devices, where setting a wakealarm further than UINT16_MAX seconds in the future would apparently overflow and wraparound... (fix#8039, many thanks to @yfede for the extensive deep-dive and for actually accurately pinpointing the issue!).
* Kobo: Handle standby transitions at full CPU clock speeds, in order to limit the latency hit.
* UIManager: Properly quit on reboot & exit. This ensures our exit code is preserved, as we exit on our own terms (instead of being killed by the init system). This is important on platforms where exit codes are semantically meaningful (e.g., Kobo).
* UIManager: Speaking of reboot & exit, make sure the Screensaver shows in all circumstances (e.g., autoshutdown, re: #9542)), and that there aren't any extraneous refreshes triggered. (Additionally, fix a minor regression since #9448 about tracking this very transient state on Kobo & Cervantes).
* Kindle: ID the upcoming Scribe.
* Bump base (https://github.com/koreader/koreader-base/pull/1524)
* Kobo: Discriminate between the Touch A/B and the Touch C properly, and implement actual support for the A/B input quirks. This means the clunky touchscreen probe widget shown on fresh installs on those devices is now gone :}.
* Input: Fix an off-by-one in most adjustTouchMirrorX/Y callers (only rM was doing it right), and adjust their documentation to avoid similar mistakes in the future.
* GestureDetector: Unify logging to always display transformed coordinates for simple gestures.
* GestureDetector: Fix two-contact hold lifts to be computed at the midpoint between the two contacts, like their holds counterpart already did.
* AutoSuspend: Use the canSuspend devcap check instead of reinventing the wheel.
* Device & UIManager: Cleanup canSuspend devcap check related stuff to avoid boilerplate code.
(It also now defaults to no, and is explicitly set by device implementations where supported).
* AutoSuspend: Re-engage suspend/shutdown timers when fully charged.
This restores the existing behavior pre #9036
(c.f., https://github.com/koreader/koreader/pull/9258#issuecomment-1167672356)
* SDL: Unbreak the fake suspend behavior so that it actually works.
Tweak the default screensaver message to remind users that Power is bound to F2.
(Fix#9262)
* AutoSuspend: Re-engage suspend/shutdown timers on unplug.
This matters on Kobo, because the unexpected wakeup guard might have stopped the suspend timer.
* LuaSettings/DocSettings: Updated readSetting API to allow proper initialization to default.
Use it to initialize tables, e.g., fixing corner-cases in readerFooter that could prevent settings from being saved.
(Fixes an issue reported on Gitter).
* LuaSettings/DocSettings: Add simpler API than the the flip* ones to toggle boolean settings.
* Update LuaSettings/DocSettigns usage throughout the codebase to use the dedicated boolean methods wher appropriate, and clean up some of the more mind-bending uses.
* FileChooser: Implement an extended default exclusion list (fix#2360)
* ScreenSaver: Refactor to avoid the pile of kludges this was threatening to become. Code should be easier to follow and use, and fallbacks now behave as expected (fix#4418).
On devices where the event time is the uptime (time since
boot), we don't need to trash it and use TimeVal:now()
and lose precision. We can still use these times for
relative delays and durations computations, which is
mostly all we use them for.
We just need a real clock time in GestureDetector for
two timers (long-press and double tap), where we do
the event time type detection on the first event, on
all devices.
* In icons mode, just use two different icons to display Wi-Fi status
* Enable Wi-Fi status icon on Kobo & Cervantes, too
* Refresh footer on (dis)connect if the Wi-Fi status item is enabled
CBB now handles nightmode correctly (by deferring to Lua), so we no longer
need to do monkey dances about disabling it when hw invert is missing.
canUseCBB cap is resolved by generic device re-configuring blitbuffer
on the go, so as to avoid repeating the same thing in every device driver.
The dev setting can now flip cbb on the go, so one can gloat at the near
meaningless perf difference - 2Mp draw is 15ms Lua / 10ms C on 1GHz Cortex A7.
* Revamped most actions that require an internet connection to a new/fixed backend that allows forwarding the initial action and running it automatically once connected. (i.e., it'll allow you to set "Action when Wi-Fi is off" to "turn_on", and whatch stuff connect and do what you wanted automatically without having to re-click anywhere instead of showing you a Wi-Fi prompt and then not doing anything without any other feedback).
* Speaking of, fixed the "turn_on" beforeWifi action to, well, actually work. It's no longer marked as experimental.
* Consistently use "Wi-Fi" everywhere.
* On Kobo/Cervantes/Sony, implemented a "Kill Wi-Fi connection when inactive" system that will automatically disconnect from Wi-Fi after sustained *network* inactivity (i.e., you can keep reading, it'll eventually turn off on its own). This should be smart and flexible enough not to murder Wi-Fi while you need it, while still not keeping it uselessly on and murdering your battery.
(i.e., enable that + turn Wi-Fi on when off and enjoy never having to bother about Wi-Fi ever again).
* Made sending `NetworkConnected` / `NetworkDisconnected` events consistent (they were only being sent... sometimes, which made relying on 'em somewhat problematic).
* restoreWifiAsync is now only run when really needed (i.e., we no longer stomp on an existing working connection just for the hell of it).
* We no longer attempt to kill a bogus non-existent Wi-Fi connection when going to suspend, we only do it when it's actually needed.
* Every method of enabling Wi-Fi will now properly tear down Wi-Fi on failure, instead of leaving it in an undefined state.
* Fixed an issue in the fancy crash screen on Kobo/reMarkable that could sometime lead to the log excerpt being missing.
* Worked-around a number of sneaky issues related to low-level Wi-Fi/DHCP/DNS handling on Kobo (see the lengthy comments [below](https://github.com/koreader/koreader/pull/6424#issuecomment-663881059) for details). Fix#6421
Incidentally, this should also fix the inconsistencies experienced re: Wi-Fi behavior in Nickel when toggling between KOReader and Nickel (use NM/KFMon, and run a current FW for best results).
* For developers, this involves various cleanups around NetworkMgr and NetworkListener. Documentation is in-line, above the concerned functions.
* generic Device:info() function which returns the model
* add Device:canSuspend() and make it true in all devices that have suspend routines and the emulator
* also enable fake poweroff/reboot on the emulator
* add Device.home_dir
* add Device:hasExitOptions() and update menus & comments
Defines new function reconnectOrShowNetworkMenu(), which iterates over
available networks ordered by signal power, and check if we can connect
to saved SSIDs. If we can, then skip network list dialog.
* remove unused setting 'internal_storage_mount_point
use filemanagerutil.getDefaultDir() instead
https://github.com/koreader/koreader/blob/master/frontend/apps/filemanager/filemanagerutil.lua#L15
* more info about device frontlight/naturalLight capabilities
* make stock reader fonts available in KOReader
* remove restore-wifi-async leftovers
* wireless: fix wpa_supplicant configuration:
make it compatible w/ debian wheezy binaries
don't try to run enable-wifi.sh more than once
