I opened and saved the project and its schematic, PCB, etc. Some got
saved with a different file name extension.
`kinx-cache.lib` had to been renamed to `kint-cache.lib` otherwise the
Schematic editor would complain that the file is missing. Then I
removed it as I was told in the IRC channel that after saving the
schematic in the new format, the symbols will be embedded and it's no
longer needed.
When opening the PCB there was a warning:
> If the zones on this board are refilled the Copper Edge Clearance
> setting will be used (see Board Setup > Design Rules > Constraints).
> This may result in different fills from previous KiCad versions which
> used the line thicknesses of the board boundary on the Edge Cuts
> layer.
The File > Board Setup > Design Rules > Constraints > Copper Edge
Clearance is 0.05mm. Clicking the board boundary belonging to the Edge
Cuts layer reveals a properties dialog with Line Width 0.05mm.
Being the same, nothing should change at the next refill.
The `.gitignore` file has been updated from its original source.
Alex Băluț