8fe85ab1dd
|
3 years ago | |
|---|---|---|
| .. | ||
| Advanced_Setup_LoRa.png | ||
| Basic_LoRa_Setup.png | ||
| Basic_Setup.png | ||
| DataReading.h | 3 years ago | |
| FDRS_Gateway2000.ino | 3 years ago | |
| README.md | ||
| defaults.h | 3 years ago | |
| fdrs_config.h | 3 years ago | |
| fdrs_functions.h | 3 years ago | |
README.md
Gateway 2.000
This is the FDRS Multiprotocol Gateway sketch. The device listens for packets over ESP-NOW, UART, LoRa, and/or MQTT, then retransmits the packets over these interfaces using rules defined in the configuration file.
The most commonly used configuration tells the device to take any ESP-NOW packet it receives and output the data over the serial port (UART):
#define UNIT_MAC 0x00
#define ESPNOWG_ACT sendSerial();
The companion for this device, connected via serial, takes any data it receives from the serial port and sends it via MQTT:
#define USE_WIFI
#define SERIAL_ACT sendMQTT();
Splitting the gateway into two devices allows you to use ESP-NOW and WiFi simultaneously without channel conflicts. You can also connect the first device to a computer with a USB-UART adapter and get the data that way, eliminating WiFi altogether.
If you have sensors that are out of range of your first gateway, you can use a gateway as a repeater. First you will set the ESPNOW1 address to that of your first gateway, then you'll direct general ESP-NOW traffic to the ESPNOW1 interface:
#define UNIT_MAC 0x01
#define ESPNOWG_ACT sendESPNOW(0x00);
